Home › Electrical › Service areas › Canoga Park
Licensed C-10 electrician
Electrician in Canoga Park, CA
Our shop is in Canoga Park, so this is our home turf — same-day looks are usually realistic here. Panel upgrades, EV chargers, sub-panels, rewires and repairs — permitted through LADBS, with no solar required.
What we see in Canoga Park homes
Canoga Park is largely postwar tract housing, and a lot of it still runs on the original service. Homes from the 1950s and early 60s were commonly built with 60 or 100 amp panels, sized for an era before central air, induction ranges, and car chargers. That is the single most common reason we get called out here.
Because we are based here, Canoga Park is the area where we can most often get eyes on a problem quickly — which matters when the complaint is something like a burning smell or a breaker that will not stay reset. Those are not "book it for next week" calls. Being local also means we already know the counter staff and the inspection rhythm, which takes guesswork out of the schedule we quote you.
EV charging in Canoga Park
Most Canoga Park tract homes have an attached garage with the panel either inside it or on the exterior wall right behind it. That is close to the ideal case for a charger install — a short run from panel to charger, minimal wall penetration, and no trenching. The limiting factor here is almost always panel capacity rather than physical placement.
Permits and the utility in Canoga Park
Electrical work in Canoga Park is permitted through the Los Angeles Department of Building and Safety, and anything that touches the service itself involves the Los Angeles Department of Water and Power. Those are two separate processes with two separate schedules, and they are the main reason a panel upgrade takes longer on the calendar than it does in labor hours.
We pull the permit and coordinate the utility disconnect and reconnect as part of the job. You get a flat written price before we start, and the work is inspected — which matters more than most homeowners realize, because unpermitted electrical work surfaces during escrow and becomes expensive at the worst possible moment.
Electrical services in Canoga Park
Main panel upgrades
Replacing an undersized or obsolete service — typically 60 or 100 amp — with a modern 200 amp panel. This is the job that unlocks everything else: EV charging, heat pumps, induction, and solar with a battery.
EV charger installation
A dedicated 240 volt circuit for a home charger, run properly and on permit. If your panel cannot carry the load, we tell you that before you buy the charger rather than after.
Sub-panels and dedicated circuits
Detached garages, workshops, ADUs, pool equipment, and remodels that need their own capacity instead of another breaker crammed into a full panel.
Rewiring and code corrections
Ungrounded outlets, obsolete wiring methods, and work from previous owners that was never done to code. Common in older homes and often found during a sale.
Troubleshooting and repair
Breakers that keep tripping, dead circuits, flickering lights, burning smells. Diagnosis first — we find the actual cause rather than replacing parts until it stops.
Questions from Canoga Park homeowners
Do you need a permit for a panel upgrade in Canoga Park?
Yes. A main panel upgrade is permitted work, and in Canoga Park that goes through the Los Angeles Department of Building and Safety. It also involves the Los Angeles Department of Water and Power, because the service has to be disconnected and reconnected to swap the panel. We handle the permit and coordinate the utility side — you should be suspicious of any contractor who offers to skip it, because unpermitted electrical work becomes your problem when you sell.
How long does a panel upgrade take in Canoga Park?
The physical work is usually a single day, with the power off for a good portion of it. The longer variable is scheduling the LADBS inspection and the LADWP disconnect and reconnect, which is why the full timeline is typically longer than the labor alone. We give you the realistic calendar up front, not just the install day.
Do I need to have solar to hire you in Canoga Park?
No. We are a licensed C-10 electrical contractor and take electrical work on its own — panel upgrades, chargers, rewires, repairs — with no solar attached and no obligation to consider it.
What does electrical work cost in Canoga Park?
We quote flat prices per job rather than hourly, and we will not give you a number over the phone for anything involving your service — that is how people end up with a quote that changes on install day. What moves the price in Canoga Park specifically is the housing stock described above: the age of the existing service, how much previous work has to be corrected, and the physical run from the meter to where the new capacity is needed. We look, we price it, and the written number is the number.
Get a free Canoga Park electrical quote
A licensed electrician looks at the actual work and gives you a flat written price. No sales pitch, no obligation.
Get my free quote or call (818) 280-3973