Home › Electrical › Service areas › Encino
Licensed C-10 electrician
Electrician in Encino, CA
Encino is an easy run east from our Canoga Park shop. Panel upgrades, EV chargers, sub-panels, rewires and repairs — permitted through LADBS, with no solar required.
What we see in Encino homes
Encino has larger lots and a lot of mid-century ranch homes, many of them since renovated. Big single-story footprints mean long circuit runs and, frequently, sub-panels added to serve a remodeled wing or a pool. When a home like that adds a charger or a heat pump, the question is usually whether the existing service can carry it, not whether there is somewhere to put the breaker.
Sprawling single-story floor plans create a specific Encino pattern: multiple sub-panels added over decades, each one solving that year's problem, none of them planned as a system. We are often asked to sort out which panel actually feeds what before doing anything else. That mapping is worth doing properly — it is the difference between adding capacity where you need it and adding it where there happens to be room.
EV charging in Encino
Pool equipment, detached guest quarters, and long driveways all compete for the same service capacity in Encino. Before quoting a charger we look at the whole load, because on a property like this the panel that is closest is not always the panel that should carry it.
Permits and the utility in Encino
Electrical work in Encino is permitted through the Los Angeles Department of Building and Safety, and anything that touches the service itself involves the Los Angeles Department of Water and Power. Those are two separate processes with two separate schedules, and they are the main reason a panel upgrade takes longer on the calendar than it does in labor hours.
We pull the permit and coordinate the utility disconnect and reconnect as part of the job. You get a flat written price before we start, and the work is inspected — which matters more than most homeowners realize, because unpermitted electrical work surfaces during escrow and becomes expensive at the worst possible moment.
Electrical services in Encino
Main panel upgrades
Replacing an undersized or obsolete service — typically 60 or 100 amp — with a modern 200 amp panel. This is the job that unlocks everything else: EV charging, heat pumps, induction, and solar with a battery.
EV charger installation
A dedicated 240 volt circuit for a home charger, run properly and on permit. If your panel cannot carry the load, we tell you that before you buy the charger rather than after.
Sub-panels and dedicated circuits
Detached garages, workshops, ADUs, pool equipment, and remodels that need their own capacity instead of another breaker crammed into a full panel.
Rewiring and code corrections
Ungrounded outlets, obsolete wiring methods, and work from previous owners that was never done to code. Common in older homes and often found during a sale.
Troubleshooting and repair
Breakers that keep tripping, dead circuits, flickering lights, burning smells. Diagnosis first — we find the actual cause rather than replacing parts until it stops.
Questions from Encino homeowners
Do you need a permit for a panel upgrade in Encino?
Yes. A main panel upgrade is permitted work, and in Encino that goes through the Los Angeles Department of Building and Safety. It also involves the Los Angeles Department of Water and Power, because the service has to be disconnected and reconnected to swap the panel. We handle the permit and coordinate the utility side — you should be suspicious of any contractor who offers to skip it, because unpermitted electrical work becomes your problem when you sell.
How long does a panel upgrade take in Encino?
The physical work is usually a single day, with the power off for a good portion of it. The longer variable is scheduling the LADBS inspection and the LADWP disconnect and reconnect, which is why the full timeline is typically longer than the labor alone. We give you the realistic calendar up front, not just the install day.
Do I need to have solar to hire you in Encino?
No. We are a licensed C-10 electrical contractor and take electrical work on its own — panel upgrades, chargers, rewires, repairs — with no solar attached and no obligation to consider it.
What does electrical work cost in Encino?
We quote flat prices per job rather than hourly, and we will not give you a number over the phone for anything involving your service — that is how people end up with a quote that changes on install day. What moves the price in Encino specifically is the housing stock described above: the age of the existing service, how much previous work has to be corrected, and the physical run from the meter to where the new capacity is needed. We look, we price it, and the written number is the number.
Get a free Encino electrical quote
A licensed electrician looks at the actual work and gives you a flat written price. No sales pitch, no obligation.
Get my free quote or call (818) 280-3973