Home › Electrical › Service areas › Sherman Oaks
Licensed C-10 electrician
Electrician in Sherman Oaks, CA
Sherman Oaks is a straight run east along the 101 from our Canoga Park shop. Panel upgrades, EV chargers, sub-panels, rewires and repairs — permitted through LADBS, with no solar required.
What we see in Sherman Oaks homes
Sherman Oaks runs from flats near the freeway up into the hills south of Ventura Boulevard. The hillside homes often have older services, tight or awkward panel locations, and detached garages down long driveways — all of which affect what an EV charger install actually involves. The flats include a good deal of 1930s through 1950s construction where the original wiring methods are simply no longer to code.
Sherman Oaks has a high proportion of homes that have been remodeled at least once, and remodels are where we find the most inherited problems. A kitchen redone in the 1990s on top of 1940s wiring, a bathroom circuit tapped off a lighting run, recessed lighting added without regard for the load already on that breaker. None of it announces itself until you add one more thing.
EV charging in Sherman Oaks
Hillside Sherman Oaks properties frequently park below or above the house rather than beside it. That turns a charger install into a question of routing and distance, sometimes with a sub-panel closer to the parking as the cleaner answer than one very long circuit.
Permits and the utility in Sherman Oaks
Electrical work in Sherman Oaks is permitted through the Los Angeles Department of Building and Safety, and anything that touches the service itself involves the Los Angeles Department of Water and Power. Those are two separate processes with two separate schedules, and they are the main reason a panel upgrade takes longer on the calendar than it does in labor hours.
We pull the permit and coordinate the utility disconnect and reconnect as part of the job. You get a flat written price before we start, and the work is inspected — which matters more than most homeowners realize, because unpermitted electrical work surfaces during escrow and becomes expensive at the worst possible moment.
Electrical services in Sherman Oaks
Main panel upgrades
Replacing an undersized or obsolete service — typically 60 or 100 amp — with a modern 200 amp panel. This is the job that unlocks everything else: EV charging, heat pumps, induction, and solar with a battery.
EV charger installation
A dedicated 240 volt circuit for a home charger, run properly and on permit. If your panel cannot carry the load, we tell you that before you buy the charger rather than after.
Sub-panels and dedicated circuits
Detached garages, workshops, ADUs, pool equipment, and remodels that need their own capacity instead of another breaker crammed into a full panel.
Rewiring and code corrections
Ungrounded outlets, obsolete wiring methods, and work from previous owners that was never done to code. Common in older homes and often found during a sale.
Troubleshooting and repair
Breakers that keep tripping, dead circuits, flickering lights, burning smells. Diagnosis first — we find the actual cause rather than replacing parts until it stops.
Questions from Sherman Oaks homeowners
Do you need a permit for a panel upgrade in Sherman Oaks?
Yes. A main panel upgrade is permitted work, and in Sherman Oaks that goes through the Los Angeles Department of Building and Safety. It also involves the Los Angeles Department of Water and Power, because the service has to be disconnected and reconnected to swap the panel. We handle the permit and coordinate the utility side — you should be suspicious of any contractor who offers to skip it, because unpermitted electrical work becomes your problem when you sell.
How long does a panel upgrade take in Sherman Oaks?
The physical work is usually a single day, with the power off for a good portion of it. The longer variable is scheduling the LADBS inspection and the LADWP disconnect and reconnect, which is why the full timeline is typically longer than the labor alone. We give you the realistic calendar up front, not just the install day.
Do I need to have solar to hire you in Sherman Oaks?
No. We are a licensed C-10 electrical contractor and take electrical work on its own — panel upgrades, chargers, rewires, repairs — with no solar attached and no obligation to consider it.
What does electrical work cost in Sherman Oaks?
We quote flat prices per job rather than hourly, and we will not give you a number over the phone for anything involving your service — that is how people end up with a quote that changes on install day. What moves the price in Sherman Oaks specifically is the housing stock described above: the age of the existing service, how much previous work has to be corrected, and the physical run from the meter to where the new capacity is needed. We look, we price it, and the written number is the number.
Get a free Sherman Oaks electrical quote
A licensed electrician looks at the actual work and gives you a flat written price. No sales pitch, no obligation.
Get my free quote or call (818) 280-3973